Projekt Kab17
Aus Opennet
Version vom 28. August 2016, 10:14 Uhr von MathiasMahnke (Diskussion | Beiträge)
Inhaltsverzeichnis |
Info
Ein Opennet Knoten (Am Kabutzenhof 17) mit Dachinstallation, mehreren Hausbewohnern und 5 Ghz Uplinks. Kontakt über Mathias.
Status
AP1.4 - vor 27 Sekunden, Up: 15171443.20, Load: 0.40 0.77 0.84, VPN: gw / up
AP1.27 - vor 27 Sekunden, Up: , Load: , VPN: gw / up
AP1.36 - 12:39:03 13.01.24, Up: , Load: , VPN: gw / up
AP1.160 - vor 27 Sekunden, Up: , Load:
AP1.188 - vor 27 Sekunden, Up: 15171381.49, Load: 0.55 0.56 0.54
AP1.191 - vor 27 Sekunden, Up: 15173426.52, Load: 1.73 0.85 0.68
Historie
- besteht bereits seit Beginn des Opennet 2005 in Rostock, wurde mehrfach umgebaut
- Juli 2012 - Umstellung auf neuen Mast mit 3x UBNT Nanostation M5 HP und 1x UBNT Bullet 5
- April 2013 - Erweiterung im Haus mit Power-LAN AP1.36
- Oktober 2013 - Erweiterung im Haus per 5 Ghz WLAN AP1.149
- 2014 - Umbau AP1.36 von Power-LAN auf neu gezogenes Ethernet Kabel
- Juli 2016 - Installation neuer AP1.27 (TP-Link WDR4300), UBNT Bullet Rundstrahler wird zu AP1.4
- August 2016 - Umstellung auf neue Switche auf Basis UBNT ToughSwitch
Aktueller Stand
Geräteübersicht:
- AP1.4 als 5 Ghz Rundstrahler Außen "rundstrahler.kab17.on-i.de" (Master, CH100, 50 mW)
- AP1.27 als Router für drahtgebundene Hausbewohner sowie 2.4 / 5 Ghz Rundstrahler Innen "olsr.opennet-initiative.de" (Ad-Hoc, CH1, 1 mW) + "dach.kab17.on-i.de" (Master, CH64, 5 mW)
- AP1.36 als Router für drahtgebundene Hausbewohner 2.4 Ghz Rundstrahler Innen "olsr.opennet-initiative.de" (Ad-Hoc, CH1, 1 mW)
- AP1.160 als 5 Ghz Anbindung zum Projekt Bauamt AP1.177 (Client, CH108)
- AP1.188 als 5 Ghz Anbindung zum Projekt Borwinschule AP1.55 (Client, CH116)
- AP1.191 als 5 Ghz Anbindung zum Projekt YCW AP1.92 (Client, CH104)
- "switch-kab171" UBNT ToughSwitch TS5 https://switch-kab171.on 192.168.5.17 (per OLSR HNA eingebunden)
- "switch-kab172" UBNT ToughSwitch TS5 https://switch-kab172.on 192.168.5.18 (per OLSR HNA eingebunden)
- "pdu-kab17" Koukaam NETIO-230B Intelligent Power Controller http://pdu-kab17.on 192.168.5.19 (per OLSR HNA eingebunden)
Belegung Switch1:
- Port Mgnt = ONI-Mesh (Non-PoE Management)
- Port 1 = TRUNK Port (ONI-Lan1, ONI-Mesh), AP1.4 (Passive PoE)
- Port 2 = ONI-Mesh, AP1.27 (Kein PoE)
- Port 3 = ONI-Mesh, AP1.36 (Passive PoE)
- Port 4 = ONI-Mesh, AP1.160 (Passive PoE)
- Port 5 = TRUNK (LAN, WAN, ONI-Lan1, ONI-Lan2, ONI-Mesh), mycr-switch2 (Non-PoE)
Belegung Switch2:
- Port Mgnt = ONI-Mesh (Non-PoE Management)
- Port 1 = ONI-Mesh, AP1.188 (Passive PoE)
- Port 2 = ONI-Mesh, AP1.191 (Passive PoE)
- Port 3 = ONI-Mesh, frei (Non-PoE)
- Port 4 = ONI-Lan1, frei (Non-PoE)
- Port 5 = TRUNK (LAN, WAN, ONI-Lan1, ONI-Lan2, ONI-Mesh), mycr-switch1 (Non-PoE)
VLAN Switch:
- 1 = LAN, Management Switch, nicht in Verwendung
- 2 = WAN, ehem. Internet Router für AP1.4, nicht in Verwendung
- 3 = ONI-Lan1, 172.16.0.0/24 Opennet LAN von AP1.4
- 4 = ONI-Mesh, 192.168.0.0/16, Opennet Mesh zw. allen OLSR-Geräten
- 5 = ONI-Lan2, 172.17.0.0/24, Opennet LAN von AP1.27
VLAN AP1.4:
- eth0.3" (lan)
- eth0.4" (on_eth_0)
- eth0.2" (wan)
VLAN AP1.27:
- eth0.1" (lan) - LAN1+2
- eth0.2" (wan) - WAN
- eth0.3" (on_eth_0) - LAN3+4
Verkablung:
- 1 - Cat5 Kabel in ehem. Schornstein (Flur) für AP1.27
- 2 - Cat5 Kabel in Lüftungsrohr (Abstellraum) für AP1.36
Strom:
HNA Switch/Stromleiste auf AP1.4:
uci add network route uci set network.@route[0]=route uci set network.@route[0].interface=on_eth_0 uci set network.@route[0].target=192.168.5.17 uci add network route uci set network.@route[1]=route uci set network.@route[1].interface=on_eth_0 uci set network.@route[1].target=192.168.5.18 uci add network route uci set network.@route[1]=route uci set network.@route[1].interface=on_eth_0 uci set network.@route[1].target=192.168.5.19 uci add olsrd Hna4 uci set olsrd.@Hna4[0]=Hna4 uci set olsrd.@Hna4[0].netaddr=192.168.5.17 uci set olsrd.@Hna4[0].netmask=255.255.255.255 uci add olsrd Hna4 uci set olsrd.@Hna4[1]=Hna4 uci set olsrd.@Hna4[1].netaddr=192.168.5.18 uci set olsrd.@Hna4[1].netmask=255.255.255.255 uci add olsrd Hna4 uci set olsrd.@Hna4[1]=Hna4 uci set olsrd.@Hna4[1].netaddr=192.168.5.19 uci set olsrd.@Hna4[1].netmask=255.255.255.255 uci add firewall redirect uci set firewall.@redirect[1]=redirect uci set firewall.@redirect[1].src=on_mesh uci set firewall.@redirect[1].dest=on_mesh uci set firewall.@redirect[1].proto=all uci set firewall.@redirect[1].target=SNAT uci set firewall.@redirect[1].dest_ip=192.168.5.17 uci set firewall.@redirect[1].src_dip=192.168.11.4 uci add firewall redirect uci set firewall.@redirect[2]=redirect uci set firewall.@redirect[2].src=on_mesh uci set firewall.@redirect[2].dest=on_mesh uci set firewall.@redirect[2].proto=all uci set firewall.@redirect[2].target=SNAT uci set firewall.@redirect[2].dest_ip=192.168.5.18 uci set firewall.@redirect[2].src_dip=192.168.11.4 uci add firewall redirect uci set firewall.@redirect[2]=redirect uci set firewall.@redirect[2].src=on_mesh uci set firewall.@redirect[2].dest=on_mesh uci set firewall.@redirect[2].proto=all uci set firewall.@redirect[2].target=SNAT uci set firewall.@redirect[2].dest_ip=192.168.5.19 uci set firewall.@redirect[2].src_dip=192.168.11.4 uci commit
ToDo
- eine Loco M5 Kappe austauschen
- Wechsel Software APs auf Stable Release
- SSIDs prüfen + ggf. überarbeiten
- Backbone Doku erweitern
- Monitoring
Links
- Bilder (aktueller Stand): https://www.opennet-initiative.de/gallery3/index.php/standorte/Kabhof17/Erneuerung-2012
- Bilder (alter Stand): https://www.opennet-initiative.de/gallery3/index.php/standorte/Kabhof17/